All the parts have now arrived for my project! which is a …….
Parts for my project
The parts and where I purchased them from are as follows:- (UK, US and China!)
- Jetson Nano
- Samsung 64GB 100MB/s (U3) MicroSD EVO Select Memory Card with Adapter (MB-ME64GA/AM)
- DC Gearbox Motor TT Motor 200RPM Tire Wheel DC 3-6V for Arduino Smart Car 1:48 Male Connector (Pack of 2 Sets)
- Motor Driver – DC Motor + Stepper FeatherWing Add-on For All Feather Boards
- 1″ Diameter Caster Ball (1 inch Diameter Solid Delrin Polyoxymethylene (POM) / Celcon Plastic Balls)
- 10,000mAh Power Bank Battery with two 5v/3A USB outputs – email me about this! (after discussions with the manufacturer Topstar, this battery is now available in the UK via Amazon UK and it fits)
- USB cable pack Type A to Micro, right angle
- PiOLED display – Adafruit PiOLED – 128×32 Monochrome OLED Add-on for Raspberry Pi
- PiOLEDheader
- 3D Printed Chassis
- 3D Printed Camera Mount
- 3D Printed Caster based
- 3D Printed Caster shroud
- Raspberry Pi Camera V2 Camera
- Camera lens attachment 160-degree FoV
- M2, Intel Wireless-AC 8265 Dual Band 2.4/5GHz WiFi card
- WiFi antenna with U.FL connectors (Antenna Wi-Fi 3.3dBi Gain 2483.5MHz/5850MHz Film) (two)
- Adafruit Skinny Wheel for TT DC Gearbox Motors [ADA3757] (two)
- 20 x Hexagonal M2 screws, 8mm self tapping.
- 4 x Hexagonal M3 bolt, 20mm long.
- 4 x Hexagonal M3 nut.
- 4 x 20cm jumper wires.
- Adhesive Pads.
- Hexagonal screwdrivers
to build a JETBOT
A Nvidia Jetson Jetbot (robot)
![[Valid RSS]](http://andysworld.org.uk/images/valid-rss.png "Validate my RSS feed")