mrhyperlinkukplain Get a free Giffgaff Sim

Posts Tagged ‘algarde’

New Aquarium

Monday, August 31st, 2009

Three months ago, I reported all change in the fish house and removed 9 unsed fish tanks from the fish house and tried to replace them with a spare 48×18x12 - plans didn’t work well!, well it’s taken me three months to get the faulty aquarium replaced, and I’ve spent many hours this weekend installing the tank on it’s shelf. I’d previously removed the 2 x 24×12x15 and 18×18x18 cube from this shelf. So I just needed to slot this tank in place and wire-up heaters and filters.

Algarde Digi-Therm external stat

Algarde Digi-Therm external stat

I’ve used an Algarde Digi-Therm digital external thermostat connected to two heaters (200 and 300 watt) - this is rather an old combination of using external thermostat connected to internal heaters, the norm these days is to use, combined heater thermostats, but I still prefer this older, safer combination. I’ve had many combined heater stats jam on and heat up and kill the fish in the tank.

Hagen Bio-Life 55 internal filter with trickle filter

Hagen Bio-Life 55 internal filter with trickle filter

Filtration is provided by a Hagen Bio-Life 55, internal Wet ‘n’  Dry internal filter, and excellent internal filter - I’ve had to start this filter from new, so it’s not mature yet, and will take several weeks to mature and

homebrew tank hangers for biolife 55

homebrew tank hangers for biolife 55

I had to make some homebrew clips to secure the fish tank to the side of the tank, as this tank is 18″ deep, I’ve lost the suckers or bracket to stick to tank wall , I was going to use a Dennerle C400 internal filter, but I prefer this filter because it has an internal trickle filter (they were all the rage, once upon a time). I’ve also installed an air-driven

Algarde Bio-foam 200 sponge filter

Algarde Bio-foam 200 sponge filter

Algarde Bio-Foam 200 internal foam filter using four foams, this was easy to mature, because I just stole a foam from other tanks in the fish house which are already mature, as most tanks in the fish house have air-driven Algarde Bio-Foam 200 internal foam filter using two foams - so I ust removed one foam and replaced with a new, and made sure the mature foam was pre-washed in old aquarium water. I’m hoping that this speeds up maturation of the aquarium. I’ve also installed a sand filter,

Lifegard FB300 Fluidized Sand Filter (fully Fluidized!)

Lifegard FB300 Fluidized Sand Filter (fully Fluidized!)

a Lifegard FB300 driven by a Maxijet PH600 powerhead. I don’t think you can ever “over-filter” a tank. I had a small issue with this filter, because after filling it with media (sand), the powerhead wouldn’t drive it correctly, even after testing it correcly before filling, so I had to empty the sand into a bucket, re-connect the filter, run the powerhead, and re-fill the filter with a 5ml spoon of sand at a time to prevent clogging, it took a while re-filling the filter with sand, a few spoonfuls!

top of tank showing water movement

top of tank showing water movement

Tank water looks a bit cloudy at present, but give it a week, and I’m sure this will clear, as the bacteria start to work their magic.

Post to Twitter